(Fujitsu) General Australia and New Zealand

This configuration guide outlines the DIP switch positions and refrigerant circle addressing for J-III series single-phase outdoor units. Models Covered ...

This chart defines the DIP switch (SW1, SW2) configurations used to set the indoor unit capacity during installation or service. Purpose Each DIP switch c...

This reference chart outlines configurable function codes and options for Fujitsu General VRF indoor units, covering Ducted, Cassette, Ceiling, Wall-Mounted...

This guide provides diagnostic steps for verifying correct operation of the Electronic Expansion Valve (EEV) used in Fujitsu VRF J-Series systems. Applicab...

Part No. 9601705017 (Motor Induct) This service information outlines the correct diagnostic procedure to verify the operation and electrical integrity of ...

Part No.: 9372716014 (Compressor ASSY) Applicable System: Fujitsu General J-Series VRF Check Point 1: Circuit Connection Verify terminal wiring between...

Part No.: 9705253032 (TR ASSY) Purpose: To verify electrical integrity and signal exchange between the Control PCB and TR PCB (IPM Drive & Power Section...

Part No.: 9707278019 (Active Filter Module) Purpose: To verify the electrical integrity and output performance of the AFM, which controls power factor and ...

Power Relay (P/No. 9900262013) Check Point 1: Circuit Connection and Coil Resistance Verify the connection at CN12 on the Control PCB (PWB ASSY). Me...