If your myanywAiR adaptor needs to reconnect to a new modem, router, or Wi-Fi network, you’ll need to reset the existing Wi-Fi configuration.
Follow the steps below to clear the previous SSID and reconfigure your connection.
Step 1. Enter Wi-Fi Configuration Mode
Locate the Reset/Function button on the myanywAiR device.
Press and hold the button for 10 seconds.
During this time, the LED will begin blinking green, indicating the device is resetting.
When the LED turns solid green, the reset is complete, and the device is now in configuration mode — ready for new Wi-Fi setup.
Step 2. Reconnect to Wi-Fi
Open your smartphone, tablet, or computer and go to Wi-Fi Settings.
Connect to the temporary network named “INTESISHOME_xxxxx” or “ANYWAIR-I-xxxxx.”
Note: This network does not have internet access during setup.
Open a web browser and type the following address:
? http://192.168.4.1Enter your Wi-Fi network name (SSID) and password carefully (both are case-sensitive).
Click “Configure Wi-Fi.”
Step 3. LED Status During Setup
Use the LED colour and blinking pattern to monitor connection progress:
| LED Colour | Behavior | Meaning |
|---|---|---|
| Green (Steady) | — | Device ready to connect |
| Green (Blinking) | — | Checking configuration |
| Yellow (Blinking) | — | Downloading configuration |
| Red (Blinking) | — | Connecting to access point |
| Off | — | Configuration complete, connected successfully |
| Red/Green (Alternate) | — | Error connecting to router (check SSID or password) |
| Yellow/Green (Alternate) | — | Server not reached (check internet connection) |
Expected LED sequence during setup:
? Green Steady → Green Blinking → Yellow Blinking → Red Blinking → Off
Step 4. Confirm Connection
Once the LED turns off, the myanywAiR device is successfully connected and online.
You can now control your air conditioner again using the myanywAiR app.
Tips for Reliable Setup
Ensure your Wi-Fi is 2.4 GHz (5 GHz is not supported).
Keep the device within 3–5 meters of the router during setup.
Double-check that your Wi-Fi name and password are entered exactly as they appear (case-sensitive).
If setup fails, repeat the 10-second reset and try again.
